Building A Calculator – Part 1 – Introduction

Here is what I would consider a pretty ambitious project.

On the surface, this might seem like a pretty simple project but I found it to be a pretty good challenge.

For those of you who are interested, I will be putting together a multi-part series on how to craft the STAGCALC 3000

For starters – take a look at it and test it out. Obviously, I don’t have time to test every possible calculation so perhaps there is a bug or two – or thirty.
If you find one, please let me know.

Currently – as you’ll read in the working project – you do need to clear the display after each calculation that is done. No ability to perform one after the next in series. Also I have limited the small display to a range of -99999999 to 99999999. If you generate something larger or smaller than that you will get an error.

Read the full story by


Blended Learning and How it Redefines Teachers’ Roles Pausing Issue
We are updating our Privacy Policy, so please make sure you take a minute to review it. As of May 25, 2018 your continued use of our services will be subject to this new Privacy Policy.
Review Privacy Policy OK